SH1107 OLED driver

Support is included in the SH1107 (About Modules) module, using the Graphics library.

This module is very similar to the SH1106 module, but with different initialisation commands to make it work with the SH1107. This hasn't been tested with 128x128 displays, only a 128x64 display.

The display shown can be set to operate in one of three modes by changing links on the pcb.

The modes are 4-wire SPI (with a D/C pin), 3-wire SPI, and I2C.

Other variants have only the I2C mode available, and 4 pins on the header: VCC, GND SDA & SCL.

SPI

SPI 3-wire isn't supported by this driver, only 4-wire is.

I2C

Just wire up as follows:

Software

function start(){
 // write some text
 g.drawString("Hello World!",2,2);
 // write to the screen
 g.flip(); 
}

// I2C
I2C1.setup({scl:B6,sda:B7});
var g = require("SH1107").connect(I2C1, start);

// SPI
var s = new SPI();
s.setup({mosi: B6 /* D1 */, sck:B5 /* D0 */});
var g = require("SH1107").connectSPI(s, A8 /* DC */, B7 /* RST - can leave as undefined */, start);

Note: This module uses a double buffer, which means you need to call g.flip() before any changes take effect.

128x32 or 128x128

By default the module is configured for 128x64 OLEDs. If you want to use 128x32 or 128x128 OLEDs, you must specify the height in the optional last argument. This has not yet been tried.

// I2C
require("SH1107").connect(I2C1, start, { height : 32 });
// SPI
require("SH1107").connectSPI(s, A8 /* DC */, B7 /* RST */, start, { height : 32 });

Chip Select (CS)

By default, chip select on the SPI OLEDs isn't used. You can however enable it with the following:

require("SH1107").connectSPI(s, A8 /* DC */, B7 /* RST */, start, { cs : MY_CS_PIN });

Non-standard I2C addresses

Some I2C modules are configured such that they aren't on the normal I2C address of 0x3C.

Also, if pin DC is tied to 3.3V.

If this is the case then you'll have to explicitly specify the address:

require("SH1107").connect(I2C1, start, { address : 0x3D });

Contrast

You can set the contrast after initialisation using g.setContrast(31) with a value between 0 and 255.

However you can also set this at startup, using the options object:

require("SH1107").connect(I2C1, start, { 
  contrast : 31,
});

ESP32 / M5Stick configuration

To use this module with the display in the M5Stick, you need the following configuration:

SPI2.setup({ sck:D18, mosi:D23 });
var g = require("SH1107").connectSPI(SPI2, D27, D33, start, {cs: D14});

Using

(No tutorials are available yet)